Amazing GOOP® comes in a carded 1.0 oz tube containing thick adhesive that permanently bonds and seals. It’s clear, waterproof, paintable and even washer and dryer safe. This multi-purpose adhesive is great when a permanent bond is needed.
COMMONLY USED SURFACE-TO-SURFACE APPLICATIONS ARE:
- Glass / Rhinestone
- Clay Pottery / Rocks / Sea Shells
- Beads / Fabric
- Ceramic / Wood
- Glass / Metal
DIRECTIONS & TIPS FOR USING AMAZING GOOP:
- Apply GOOP® directly to each surface to be bonded.
- Allow GOOP® to partially cure 2-10 minutes before bringing surfaces together.
Note: GOOP® hardens by solvent evaporation and forms an immediate bond that is difficult to reposition after both adhesive-coated surfaces are placed in contact with each other and sufficient pressure is exerted to establish full contact.
SPECIAL TIPS: To extend the life of the product, be sure cap is secured back to original position. Use a toothpick as a disposable applicator for very small applications such as beading. Remove, recap, and allow the plastic nozzle to dry. Remove dried product from nozzle by pulling out through the threaded end and reuse the nozzle.
CURE RATE & DRYING TIME: Fully cures in 24 to 72 hours at approximately 70 degrees F. Curing time is effected by temperature.
GAP FILLING ABILITY: Up to ¼-inch
CLEAN UP & REMOVAL RECOMMENDATIONS: Uncured GOOP® can be cleaned by using small amounts of solvents such as Acetone, Tolulene or Naphtha. Cured GOOP® requires scraping or cutting away product with sharp knife and use of mineral spirits (i.e. gasoline, lighter fluid, lacquer thinner) to soften product.
CAUTION ADVISORIES OR SAFETY RECOMMENDATIONS: Use GOOP® in a well ventilated area. GOOP® may damage finished surfaces. Avoid prolonged contact until GOOP® is completely dry. Do not dry clean.
- Non Toxic
- Kid Friendly
- Dries Clear