Autumnal Dreams Light
- KraftyBlok™ Original
- KraftyBlok™ Large Stand
- Adirondack® Alcohol Inks, Farmer’s Market Collection
- Foam Brush, 1-inch
- Versamark Ink Pad
- Tree Stamp (of your choice)
- Embossing Powder, Black and Gold
- Heat Gun
- Night Light (on a cord)
- Silicone Candle Bulb, 5-watt
- Beaded Fringe, 20-inches (in a coordinating color)
- Hot Glue and Gun
- Paper Towels
Protect your work area with several layers of newspaper.
Clean your block with glass cleaner and a paper towel.
Place the KraftyBlok™ face down on a flat work surface with the opening facing towards you.
Remove the cap from your first bottle of alcohol ink. Squirt a bit of ink onto the KraftyBlok™ surface. To avoid spills, place a paper towel over the tip of the ink bottle, then invert. Squirt a small puddle of ink. Repeat this process with as many colors you choose to use.
Tilt the KraftyBlok™ from side to side, back and forth distributing the ink across the surface of the glass, moving quickly.
Apply several drops of alcohol ink to the tip of a 1-inch foam brush. Using long quick strokes, apply ink to the sides, top and bottom of the block. Allow ink to dry completely.
Stand the block up with the opening facing down on the newspaper. Apply alcohol inks to the sides of the block in alternating colors. Allow the inks to run down the sides. Continue to create runs until you are satisfied with the look. Touch up with the foam brush on edges if necessary. Allow ink to dry.
When dry, place the KraftyBlok™ on the work surface with the opening facing up.
Using a VersaMark inkpad and ink a "tree" stamp of your choice. Carefully stamp the glass several times creating multiple images as shown in the photograph. Feel free to overlap stamped images.
Sprinkle embossing powder over the tree images, making sure all trees have powder sticking to them. Tap off the excess powder.
Using the embossing gun, melt the powder until it is smooth. Be careful not to overheat, which will cause the embossing powder to bubble.
Allow KraftyBlok™ to cool.
Remove the KraftyBlok™ stopper and place the KraftyBlok™ in the stand with the opening at the bottom. Insert a 5-watt silicone candle bulb on a night light cord into the opening. The silver prongs on the light cord will snap into the opening at the bottom of the stand and hold the light upright.
Add trim to the base of the stand by placing a dot of hot glue on one leg of the stand beneath the KraftyBlok™. Stretch the trim across the stand front and glue to secure in place. Continue this process until the trim is wrapped completely around the bottom of the stand. Add additional dot of hot glue if necessary to keep the fringe in place and from drooping.