BOO-ti-ful Spirits Banner
Add to Favorites Print

BOO-ti-ful Spirits Banner

Set your Halloween decorations aglow! The Tulip® Glow Paint Party Pack and Aleene’s® Fabric Fusion™ help you transform a plain black T-shirt into this not so spooky Halloween banner that’s a welcome sight both day and night.

Designed by Cheryl Ball, courtesy of iLoveToCreate™, a Duncan Enterprises Company

Craft Time: 60+ minutes
Uses Recycled Items: No
 
 
 
 
Get exclusive offers about this product and more!
 
 
 

Material List

  • Tulip® Glow Paint Party Pack
  • Aleene’s® Fabric Fusion™ Fabric Adhesive™
  • Tulip® Craft Mat™ (9-inches x 9-inches)
  • Scissors
  • Ribbons (assorted colors desired)
  • White Chalk (sharpened to a point)
  • Straight Pins
  • Paper Towels
 

Project Instructions

Note: Click on the Download Pattern button on the bottom right of the page for the pattern designs.
 

Cut out banner pattern then pin to double layer of black T-shirt. Cut out then repeat step creating a total of four pennants.
 

Flip over design pattern. Using white chalk, lightly draw over pattern lines holding up to window if needed to see lines.
 

Position first pattern, chalk side down, on first fabric pennant and hold in place. Press fingers along pattern lines to transfer design to fabric. Repeat with all designs and pennant pieces.
 

Place fabric pennant on Craft Mat – it will prevent paint from seeping through to work surface and is easy to clean. Test flow of paint on paper towel using an even pressure on bottle for a smooth line. Starting with first pennant, outline each section then fill in with color shown, applying an even coating. Use a straight pin to pop any bubble that may form. Carefully slide off Craft Mat and let dry. Repeat for remaining three pennants.


 

Measure and cut a 6-ft. length of ribbon for hanger. Center pennants along ribbon spacing approximately 4-inches between and leaving longer tails at each end. Apply a thin bead of Fabric Fusion on ribbon, position banner section in place and press to secure.


 

Using ruler on Craft Mat, measure and cut 8-inch sections from ribbons, cutting enough for about four ribbons between each pennant and at ends. Tie around long hanger ribbon as shown.

Tips

Keep tip of bottle clean by wiping with paper towels for a clean line. Pop any bubbles that may form with straight pin.