Bead Landing™ Lampwork Napkin Ring
Create these elegant napkin rings using beautiful lampwork beads. They will be sure to dress up your table setting, especially for special occasions and holiday gatherings.
Designed by Margaret Pankhurst
- Bead Landing™ Lampwork Beads
- Wire, 26ga
- Wire Cutters
Cut a 36" piece of wire.
Place one Lampwork bead onto the wire, and move it to the center point of the wire.
Place a second bead onto one side of the wire length. Bring the other wire length through the opposite hole in the bead. The wires will cross inside the bead.
Continue to place beads on the wire and cross the wires inside each bead. Be sure to center the beads on top of each other.
The ending length should be approximately 7". To complete the circle, feed the wires through the opposite end of the very first bead. Pull tightly.
Feed the wires through the opposite end of the second bead. Pull tightly. Wrap the wire tightly a couple of times around the two wires coming out of each hole of the second bead. Trim with wire cutters.