Bead Landing™ Lampwork and Ribbon Bracelet
Add to Favorites Print

Bead Landing™ Lampwork and Ribbon Bracelet

Lampwork beads and ribbon combine for a fun, flirty bracelet.

Designed by Margaret Pankhurst

Craft Time: 60+ minutes
Uses Recycled Items: No
Get exclusive offers about this product and more!

Material List

  • Bead Landing™ Chain
  • Bead Landing™ Lampwork Beads
  • Ribbons (3" Ea.) – Assorted
  • Head Pins
  • Lobster Claw Closure
  • Scissors
  • Bent Nose Pliers
  • Wire Cutters
  • Round Nose Pliers
  • Jump Rings

Project Instructions

Cut a length of chain to fit your wrist loosely, with chain cutters.  

Open a jump ring and place on it a lobster claw. Close the jump ring securely around the last link in the chain using bent nose pliers.  

Tie as many 3" lengths of coordinating ribbon to the chain length as necessary to make it nice and full.  

Place a seed bead and a Lampwork bead on a head pin. Bend the pin to form a right angle. Cut the pin approximately 1/4" beyond the bead. Use the round end of your pliers to grasp the end of the pin and curve the pin by using a rolling motion to fold it over a single round prong. Close the loop around a link in the chain.   

Continue the above procedure with each Lampwork bead until the bracelet is full.


Refer to photo for project details.