Bling Bead Ring
- Bead Landing™ Bling Beads
- Bead Landing™ Cording – Pink
- Bead Landing™ Side Cutters
- Krazy Glue®
- Masking Tape
Cut three 8" strands of pink cording. Tape the ends of the cord to a work surface, leaving a 2" tail. Note: You can also use a clipboard to hold your piece.
Make a square knot. *Take the left strand and pass over the center strand and under the right strand. Then take the right strand and pass under the center strand, then up through the loop of the left strand. Pull tight. Take the right strand and pass over the center strand and under the left strand. Then take the left strand and pass under the center strand, then up through the loop of the right strand. Pull tight.
Repeat the pattern a few more times. *Measure on your finger. Make it slightly larger than your ring size.
Trim the ends of the cording on the outside strands and glue to secure.
Insert the center strand through one green bead and tie a knot to secure.