Botanical Floral Lamp
Decorate your lamps to match your home decor with Martha Stewart Crafts® Paper Cut-outs.
Designed by Chris Williams.
- Martha Stewart Crafts® Paper Cut-outs – Botanical Floral
- Martha Stewart Crafts® Gloss Decoupage Finish
- Martha Stewart Crafts® Decoupage Brushes
- Ceramic Lamp Base and Shade
- Scissors (or Craft Knife)
- Paper Towels
- Rubbing Alcohol
Wash ceramic lamp base with soap and water. Clean with alcohol to remove any remaining dirt, grease or soap residue.
Prepare paper cut-outs by removing them from sheet. If desired, cut excess background away using scissors or a craft knife.
Using the Martha Stewart Crafts® decoupage brush, apply one even, smooth coat of Gloss Decoupage Finish to the ceramic base.
Apply the decoupage paper to the surface positioning. Press and smooth from the center towards the edges of the cut-out to remove air pockets and excess finish.
Continue adding paper cut-outs to the surface until the entire decoupage design is achieved.
Once in place and smooth, allow to dry for two hours.
When completely dry, brush a smooth application of decoupage finish over the entire surface, being sure to seal all edges of the paper. Allow to dry two hours.
Brush a second coat of decoupage finish over the entire surface and allow to dry two hours.
Air dry project for 21 days to cure.