Project Instructions

Cut six 7" pieces of flexible beading wire.

Place a crimp bead on the end of the wire and feed the end through the bead guardian. Before feeding the wire through the crimp bead again, place the bead guardian around the connecting point of the connector.

Now feed the wire through the crimp bead. Crimp the bead with the crimping pliers. Trim the excess wire with the cutters. Repeat for each wire.

Place beads onto the wire to fit half the desired length of the bracelet. Repeat for all wire lengths.

Repeat the procedure with the bead guardian and crimp beads above, connecting the ends to the clasp. Repeat for all wire lengths.