Step: 1

Read all package directions before beginning this project.

Step: 2

Place pattern under styrene blank and trace design with Liquid Leading. Let dry 8 hours.

Step: 3

Paint design as follows: Fill a section of the design with Window Color following pattern numbers (pattern numbers correspond to the last three numbers of the Window Color item number); using nut pick combing tool from tool set, smooth paint and eliminate bubbles. Repeat same steps in other sections to complete painting the design. Let dry overnight to a translucent finish.

Step: 4

Using craft knife, make small holes 1-inch from each side and ¼-inch down from top, pushing tip of knife into styrene and spin slowly right and left to create a hole.

Step: 5

Cut ribbon to desired length then thread through holes and tie at ends to keep in place.