- Jennifer Heynen Ceramic Head Pins (2)
- Assorted Glass Beads, 4mm-8mm (10)
- Jump Rings, 10mm – Gunmetal (2)
- Ear Hooks – Gunmetal (2)
Step 1 String one of the assorted glass beads onto the wire of each head pin.
Step 2 Trim each head pin wire so that it is only sticking out of the top of the bead half an inch.
Step 3 Take the end of the wire in your round nose pliers and make a loop. Do this for all ten head pins.
Step 4 Separate the head pins into two sets of five, one for each earring.
Step 5 Open up one of the jump rings, then slide on five of the head pins.
Step 6 Next, slide on one of the ear hooks. Close the ring.
Step 7 Repeat these steps for the second earring.