Champagne Ornament
Add to Favorites Print

Champagne Ornament

Create this dazzling Crystazzi® ornament for your tree or home decor.

Craft Time: 30-60 minutes
Uses Recycled Items: No
Get exclusive offers about this product and more!

Material List

  • Crystazzi® Bicone, 4mm – Smoke
  • Crystazzi® AB Bicone, 4mm – Crystal
  • Crystazzi® Bicone, 4mm – Champagne
  • Crystazzi® Satin Bicone – Light Smoke
  • Crystazzi® AB Bicone, 6mm – Crystal
  • Crystazzi® Bicone, 6mm – Champagne
  • Celebrate It® Ribbon
  • Scissors
  • Head Pins
  • Styrofoam® Ball, 1½"
  • Glue
  • Round Nose Pliers
  • Wire Cutters

Project Instructions

Cut the head off of a head pin. Form a wrapped loop at one end of the pin. Apply glue to the shaft of the pin and insert into the center of a Styrofoam® ball.

Wait 4-6 hours for the glue to set before hanging.* Use monofilament or decorative ribbon to hang the ornament.

Thread the bead patterns onto head pins.

Snip the head pin approximately ½" to ¾" past the beads. The full head pin won’t fit into the Styrofoam® ball without pushing out or warping the pins inserted on the opposite side of the ball.

Press the pins into the ball in a pattern or randomly. If using a pattern it’s easier to start along the center and make a complete row the entire distance around the ball, then press in the next row. This will help keep the rows even. Create a unique pattern by pressing the pins in randomly.

*Glue may be applied to the ends of the pins to make them more secure in the Styrofoam®. A quick drying glue is recommended unless you plan on moving the pins around. Remember that each time you remove a pin and replace it, the integrity of the Styrofoam® is weakened. Do not use Super Glue or glues not recommended for Styrofoam®.

Craft Notes

Depending on the overall design or placement of the pins, more packages may be needed. The sample uses 1-3 packages of any of the crystals and head pins.