Christmas Delight Ornament
Create this dazzling Crystazzi® ornament for your tree or home decor.
- Crystazzi® 4mm Erinite Bicone, 4mm – Erinite and Dark Siam
- Crystazzi® 6mm Erinite Bicone, 6mm – Erinite and Dark Siam
- Crystazzi® Round, 8mm – Erinite and Dark Erinite Head Pins
- Styrofoam® Ball, 1½"
- Round Nose Pliers
- Wire Cutters
Cut the head off of a head pin. Form a wrapped loop at one end of the pin. Apply glue to the shaft of the pin and insert into the center of a Styrofoam® ball.*
Wait 4-6 hours for the glue to set before hanging. Use monofilament or decorative ribbon to hang the ornament.
Thread the bead patterns onto head pins.
Snip the head pin approximately ½" to ¾" past the beads. The full head pin won’t fit into the Styrofoam® ball without pushing out or warping the pins inserted on the opposite side of the ball.
Press the pins into the ball in a pattern or randomly. If using a pattern it’s easier to start along the center and make a complete row the entire distance around the ball, then press in the next row. This will help keep the rows even. Create a unique pattern by pressing the pins in randomly.
*NOTE: Glue may be applied to the ends of the pins to make them more secure in the Styrofoam®. A quick drying glue is recommended unless you plan on moving the pins around. Remember that each time you remove a pin and replace it, the integrity of the Styrofoam® is weakened. Do not use Super Glue or glues not recommended for Styrofoam®.