Step: 1

Condition clay by kneading for 2 minutes until soft, as stated on packaging.

Step: 2

Different shapes of beads can be made using the Clay Extruder Set. After clay has been conditioned to a soft consistency, remove bottom cap, insert desired disc, insert clay into tube and replace bottom cap. Turn handle in a clockwise motion to extrude clay. Cut with craft knife or straight cutting blade. Insert needle through bead. Place beads on tray for baking. Bake in a preheated conventional or toaster oven at 275 degrees for 15 minutes per ¼-inch thickness. When finished, remove from oven and let cool before handling.

Step: 3

Insert pin head through bead hole. Add glass beads if desired. Use needle nose pliers to form loop on open end. Cut excess with pliers or wire cutter.

Step: 4

Use 2 needle nose pliers to twist open jump ring. Attach bead to jump ring and attach to bracelet.

Step: 5

Use pliers to close jump ring. Continue until all beads are attached.