Crystal Rose Wedding Necklace and Briolette Earrings
A classic statement of a crystallized pendant with crystal beads and pearls is perfect for any bride on her wedding day. Jolee’s Jewels has a wonderful selection of Swarovski Elements to create perfect jewelry for their special day.
Designed by Vickie Pozzolini for Jolee’s Jewels®
Material List
- Necklace
Jolee’s Jewels Crystal Rose Pendant, 1 Piece
Jolee’s Jewels 12x8 mm Polygon Beads, Crystal AB, 2 Pieces
Jolee’s Jewels 6mm Bicone Beads, Crystal AB, approx. 40 Pieces
Jolee’s Jewels 6mm Pearls, White, approx. 50 Pieces
Jolee’s Jewels 6mm Clear Rondelles, approx. 16 Pieces
Jolee’s Jewels 4mm Bicone Beads, Crystal AB, approx. 20 Pieces
Jolee’s Jewels Lobster Claw Closure, 1 Piece
Jolee’s Jewels Jump Rings, 2 Pieces
Jolee’s Jewels 19” Lengths of Stringing Wire, 2 Pieces
Jolee’s Jewels Crimps, 4 Pieces
Chain Nose Pliers - Briolette Earrings
Jolee’s Jewels 15 x 14mm Flat Briolette, Crystal AB, 2 Pieces
Jolee’s Jewels 6mm Bicone Beads, Crystal AB, 6 Pieces
Jolee’s Jewels 6mm Pearls, White, 6 Pieces
Ear Wires
3” Lengths of Stringing Wire, 2 Pieces
Crimps, 2 Pieces
Head pins, 12 Pieces
Jump Rings, 2 Pieces
Chain Nose Pliers
Round Nose Pliers
Flush Cutters
Project Instructions
Crystal Rose Necklace
Attach one jump ring to the loop of the lobster claw closure.
Use a crimp to attach one stringing wire to the jump ring attached to the lobster claw closure.
Thread on three 4mm Crystal AB beads.
Thread on 7 ½” to 8” inches of beads, pearls, rondelles and polygon beads, in a random pattern as desired. Thread on the Crystal Rose pendant.
Repeat steps 5 and 4.
To finish the first strand crimp the strung wire to the jump ring.
Use a crimp to attach the second stringing wire to the jump ring attached to the lobster claw closure.
Repeat steps 4 through 6. Make certain the second strand of beads has enough length to nest properly with the first strand.
To finish the second strand crimp the strung wire to the jump ring.
Test crimps to secure and carefully trim off excess stringing wire.
Briolette Earrings
Use the head pins to create single bead dangles, close with an eye pin loop. As shown: one 6mm White Pearl, make 6; one 6mm Crystal AB bead, make 6.
Thread one stringing through the briolette pendant and center.
Thread one crimp on to both stringing wires.
Pass both stringing wires through one jump ring and back into the crimp. Close the crimp to secure. Carefully trim excess wire ends.
Take half the bead dangles and attach them to the jump ring.
Attach the ear wire to the jump ring.
Repeat steps 2 through 6 for the other earring.
