Daisy Table Setting
Simple, fun, colorful! This tablesetting is perfect for Mother’s Day, welcoming Spring or just to add a bit of color and glitz anywhere!
Designed by Allee Marderosian
Material List
- Table Runner- Light Blue
- 3 Tin Pots- Turquoise
- Styrofoam ® to Fit in Pots
- Foil
- Scissors
- Wire Cutters
- 3 T-Shirts- Pink, Turquoise and Lime Green
- Excelsior Chestnut Filler
- Silk Gerbera Daisies: Fuchsia, Turquoise and Lime
- Tulip® Fashion Glitter™- Pink Jewel Hologram, Emerald Fine Jewel and Turquoise Jewel
- Tulip® Fashion Glitter Bond™
- Tulip® Sticky Fabric Stencils™- Boho 4”X8”
- Aleene’s® Crystal Clear Tacky Spray™
Project Instructions
Step: 1
Table Runner
Step: 2
Prewash table runner to remove sizing. Do not use fabric softener. Lay table runner out flat on work surface. Place stencil on table runner where desired. Refer to photo.
Step: 3
Squeeze a puddle of Glitter Bond onto a piece of foil. Dab sponge into glue. Sponge in openings of stencil. Make sure you stay inside stencil with glue.
Step: 4
Sprinkle Pink, Emerald and Turquoise Glitter over Glue. Place a clean piece of foil on top of Glitter and press down with your hand. This will push Glitter into the Glue.
Step: 5
Shake Glitter off onto scrap piece of paper. Remove stencil. Repeat for desired number of flowers.
Step: 6
Flower Pots
Step: 7
Cut off bottom half of T-shirt the width of the tins. Wrap around tin and cut to fit. Cut enough to cover all tins. Refer to photo.
Step: 8
Using Tacky Spray, spray around one tin. Immediately wrap piece of shirt around tin. Repeat for all tins.
Step: 9
Follow instructions above to apply Glitter to tins, using stencil and Glitter Bond. Apply on all pots.
Step: 10
Place piece of foam in bottom of each tin. Place Excelsior filler inside tins until it reaches top.
Step: 11
Cut stems of flowers at different lengths, using wire cutters. Push flowers straight into foam.
