Dimensional Wall Art
- FloraCraft® Foam Sheet, 10x12x1"
- FloraCraft® Foam Balls – 4", 3" and 2.5"
- Acrylic Paint – Black and Barn Red
- Scrapbook Paper, 12"x12"
- Scrapbook Embellishments – Metal Keys, Locks, Chains and Clock Parts
- Satin Ribbon, 1" – Black
- Leather Cord – Black
- Low Heat Glue Gun
- Spray Adhesive
- Weldbond® Adhesive
- Serrated Knife
- Short Pins
Step 1 Cut the three balls in half. Set aside one half of the 4" ball for a future project. Paint the half 4" ball black and the other four half balls barn red. Set aside to dry.
Step 2 Cut the scrapbook paper to fit the foam sheet. Spray adhesive on the back of the paper and glue in place on the foam sheet.
Step 3 Use the glue gun to glue the ribbon around the four sides of the foam to finish the edges. Glue leather cord to frame around the front of the paper as shown. Cut two 14" pieces of ribbon. Glue one end of each piece to the back top corners of the foam sheet and pin to secure. Hang a key from a chain and thread the end of one ribbon through the ring at other end of the chain. Knot the ribbon ends together so the key hangs in the center as shown. Trim a “V” shape into the ends of the ribbon.
Step 4 Arrange the half balls on the sheet and glue in place as shown, using the low-temp glue gun. Glue the leather cord to frame around the edge of each of the half balls.
Step 5 Arrange the embellishments onto the half balls. Press the embellishments firmly into the foam to nest them in place and use the Weldbond® adhesive to secure. Glue embellishments in around the balls to fill in if desired.