- Bead Landing™ Color Pop™ Charms – Pink Sliced Agate, Pink and Small Rhinestone
- Bead Landing™ Chain – Silver
- Bead Landing™ Earring Posts – Silver
- Bead Landing™ Jump Rings – Silver
- E-6000® Glue
- Round Nose Pliers
- Chain Nose Pliers
Step 1 Gather the Color Pop™ pink charms, Bead Landing™ silver earring posts, and the E-6000® glue. Turn both pink charms face down and add a small dot of E-6000® glue to the middle (back). Place one earring post in the center of the E-6000® glue and press firmly. Allow to dry.
Step 2 Gather the Color Pop™ pink sliced agate charms and jump rings. Insert a jump ring into the hole in the sliced agate charm. Repeat for the other charm.
Step 3 Gather the Bead Landing™ silver chain and the charms from Step 2. Measure the chain from the front of the charm to the back so that it drapes around the charm to your desired length. Remove excess chain. Repeat this step so that you have two strands that will drape on each side of the charm. Open one end of the chain and close around the jump ring on the front of the charm. Using the other end of that same piece of chain, open the chain link and close it around the jump ring at the back of the charm. Repeat this step for the other piece of chain, draping it along the opposite side of the charm.
Step 4 Using a jump ring, attach an RSVP small rhinestone charm to the two draping chains, so that it hangs down the center of the charm.
Step 5 Repeat Step 3 and Step 4 to make the charm for the second earring.
Step 6 Gather the pink charms with earring posts from Step 1 and the charms from Steps 3-5. Carefully open the jump ring in the sliced agate charm and feed it through the loop in the bottom of the pink charm and close. Make sure the dangling chain does not come loose. Repeat this sequence to complete the other earring.