Duck Tape® Robot Costume & Treat Pail
Duck® tape truly is good for anything, including creating this way cool robot costume.
Designed by Michaels Design Team
- For Both Projects
- Duck® Tape: Silver
- Foam Shapes Bucket
- Making Memories® Brads: Silver
- Sulyn Glitter Glue: Opalescent
- For Costume
- Half Mask
- Velcro® (adhesive backed)
- Creatology® Foam Sheets: Blue, Lime Green (adhesive backed)
- Chenille Stems: Silver Glitter (2)
- Black Sharpie®
- For Treat Pail
- Westrim® Paint Pail: Clear
- Creatology® Foam Sheet: Blue (adhesive backed)
- Creatology® Glitter Foam Alphabet Letters
Lay shirt and pants flat on a flat surface. Completely cover front and back with strips of silver Duck tape, slightly overlapping each piece. Cover front of mask with Duck tape, overlapping strips. Set pants and mask aside for later use.
Cut a 6-inch x 9-inch rectangle from blue foam. Place brads through foam evenly spaced around outer edge. Cut a 3-inch x 4-inch rectangle from lime foam and place on blue foam as shown. Remove backing from foam shapes and decorate rectangles as desired. Use Sharpie to add lines to green foam piece. Use glitter glue to embellish shapes.
Cut up back center of shirt. Cut small pieces of tape, place sticky sides together and attach to back of shirt to make tabs. Add Velcro to tabs for shirt closure.
Split back of pants and add Velcro to close. Note: When tape is added to pants, it will make it hard to get them on if the pants aren’t split.
Wrap chenille stems around Sharpie to coil. Remove and attach one end to holes in each side of mask. Place foam shapes over the chenille stem ends to hold them in place, as shown. Sandwich the other end of each chenille stem between two foam circle shapes. Decorate mask with additional foam shapes and glitter glue, as desired.
Completely cover the clear pail with silver duck tape.
Cut a 4-inch x 6-inch rectangle from blue foam. Push brads through foam at corners. Remove backing from foam and place on center of pail.
Add foam shapes as desired and embellish with glitter glue.
Personalize with foam letters.
Use photo as a guide and follow manufacturer’s instructions for all products used.