Project Instructions

Step 1 Attach a jump ring to each end of four chain/pearl strands.

Step 2 Attach one end of each strand to the clasp with the jump ring.

Step 3 Attach the remaining ends of the chain/pearl strands to either side of the necklace.

Step 4 Cut three 6" strands of silver chain. Gather ends of the three strands of chain into a jump ring -- one on either end.

Step 5 Attach the chain to the bottom rings of the pendant.

Step 6 Gather the chain to form a nice swag in between the rings and then gather the chain into another jump ring and attach to the other rings on the bottom of the pendant.

Step 7 Place one teardrop pearl on a head pin. Bend the pin to a right angle and trim to ¼ length.

Step 8 Using the round nose pliers, roll the end of the pin into a loop. Before closing the loop attach the pearl to the center bottom ring of the pendant.

Step 9 Repeat the above procedure with two more pearls and place on the outer rings of the pendant.