Fall Fimo® Pendant
Designed by Linda Peterson
- Fimo® Soft Polymer Clay, Copper
- Fimo® Soft Polymer Clay, Gold
- Fimo® Soft Polymer Clay, Black
- Amaco® PolyBlade
- Amaco® PolyRoller
- Amaco® Needle Tool
- Amaco® Metal Stamp Art Ink Pad, Black
- Rubber Stamp, Leaf
- Index Card
- Jewelry Cord
Draw a 2-inch triangle on an index card and cut out.
Marble a 1-inch ball of Gold and Copper clay together. Stop before color is completely mixed. Flatten to 1/8-inch.
Apply Amaco® Metal Stamp Art Ink to rubber stamp. Lightly stamp leaf pattern into clay. Place triangle over desired patterned area and cut out.
Flatten Black Fimo® Soft to 1/8-inch. Place triangle clay slab onto Black clay and cut out with PolyBlade. Roll 1/16-inch Black logs and place over pendant as desired. Wrap sides and top of pendant with thicker Black logs.
With PolyBlade, cut two small rectangular beads approximately 1/4-inch x 1/2-inch from patterned clay. Poke two holes in each with Needle Tool.
Press two small balls on top of pendant. Poke a hole in center of each ball. Roll two short 1/16-inch Black logs and wrap around two balls on top of pendant. Bake all pieces for 30 minutes at 265 degrees Fahrenheit (130 degrees Celsius) then allow to cool completely.
Cut jewelry cord to approximately 20-inches. Thread cord through holes in top of pendant. Take one end of cord and push through one hole in each bead and tie a knot. Repeat with other end of cord for adjustable pendant.
©2005 by American Art Clay Co., Inc. (AMACO®) All rights reserved. The contents may not be reproduced in any form without written permission from AMACO®. The design is not for business or commercial use, however you may make the design for your personal use or to sell for pin money. This use has been surpassed when the design is made by employees or sold through commercial outlets. The information is presented in good faith; however no warranty is given nor are results guaranteed. AMACO® disclaims any liability for untoward results.
Refer to photo to complete project.