Creatology™ Feather Headband
- Creatology™ Feathers - Color of Choice
- Creatology™ Stiff Felt - Color of Choice
- Leather (or Suede Cording)
- Low Heat Glue Gun and Glue
- Hole Punch
Cut a 1" strip of stiff felt, lengthwise.
Round the edges with scissors.
Punch a small hole in both ends about ½" from end of felt.
Glue feathers one by one on each side of the felt at a slight diagonal.
Fill in the center with a line of overlapping feathers, gluing down one at a time, all in the same direction.
Cut two pieces of leather cording, long enough to tie around to the back of your head, approximately 12" each.
Thread the leather cording through each of the punched holes and knot it tightly.
Measure by trying headband on, and tying leather cording tight, but not uncomfortable. Trim excess leather cording as needed.