Flowered Headband
Add to Favorites Print

Flowered Headband

You can create your own unique headbands with pretty flowers.
Uses Recycled Items: No
 
 
 
 
Get exclusive offers about this product and more!
 
 

Material List

  • Plain Headband, Satin – White
  • Organza Fabric (Approximately 5"x45")
  • Freezer Paper
  • Fast Finish Decoupage
  • Fabri-Tac® Glue
  • Paintbrush, Wide
  • Scissors
  • Rotary Cutter (with Decorative Edge Wave Blade)
  • Scotch® Tape
  • Craft Sticks
  • Painter’s Tape
  • Decorative Button
  • Wire Cutters
  • Felt (or Fleece), Small Piece
  • Testors One-Coat Lacquer – Purple-Licious
  • Sheer Ribbon, 3/8" – White (36")
  • Post-It® Notes
 

Project Instructions

Fast Finish decoupage is used in this project to change the texture of the fabric, giving the flowers on each headband body and preventing their edges from fraying. Applying the decoupage is easy work if you first bond the fabric to freezer paper. Do this by ironing the shiny side of the paper to the wrong side of the fabric. This only takes seconds.

When the bonding is complete, pour some decoupage in a shallow container and use a wide brush to apply it evenly to the fabric. Let it dry completely.

Using a rotary cutter with a decorative wave blade, cut seven 3" squares from the bonded fabric by tracing a Post-It® note. Cut an eighth square slightly smaller than the others.

Spray four of the large squares and the smaller one, applying purple paint more heavily on the outer edges and fading to no paint in the centers.

Spray paint the sheer ribbon purple.

When the painted squares are dry, remove the fabric from the freezer paper by attaching a piece of tape to one of the fabric corners and pulling. Also remove the paper from the unpainted fabric.

Fold all squares in half twice and cut along the folds to within 1/8" of the center. This will create the four petals of each flower section. Make several ¼" deep cuts close together on the wavy edges.

Apply a thin line of Fabri-Tac® adhesive to one side of each petal near the center.

Fold the edges of the petal together until they hold.

Repeat on all four petals of each flower section.

Cut a piece of felt into a small square measuring about ½". Using the glue, attach the center of a large painted flower section to the center of the felt. Add three more sections with centers facing each other. Attach the unpainted flower sections on top of the painted ones in the same way.

Finish assembling the flowers by centering the smaller painted section over the others. Apply pressure in the center with a craft stick to adhere all layers.

Cut the shank from the back of a decorative button with wire cutters. Glue the button to the center of the flower.

Glue one end of the painted ribbon to the inside of the headband and wind it around the band leaving ½" between wraps. Glue the opposite end of the ribbon to the inside of the band.

Glue the felt base flower to the side of headband.