Foam Floral Arrangement
Material List
- Testors Enamel Spray Lacquer Spray – Gold Metallic and Electric Pink
- Creatology™ Foam Shapes – Flower
- Dress It Up Grandma's Grab-Bag Buttons
- Floral Stem Wire
- Vase
- Styrofoam® Block
- Craft Knife
Project Instructions
Step 1 Spray floral stem wire with Gold Metallic enamel and set aside to use later.
Step 2 Spray foam flower shapes with desired colors. Hold can approximately 10-12" from foam shapes.
Step 3 Flip flowers over and spray the other side with the same color used on the first side. Let dry.
Step 4 Choose desired button and hold in the center of the flower. Start from the back of the flower, thread a floral stem wire through the buttonhole and back through the flower, leaving a half of an inch of wire. Bend the tip to secure button.
Step 5 Repeat previous step for all of the flowers.
Step 6 Spray vase with Electric Pink. Let dry. For darker shades, spray multiple coats.
Step 7 Cut foam block to fit snugly inside of the vase.
Step 8 Trim the ends of the flower stems to desired height.
Step 9 Place flower stems into the foam and arrange as desired.
Testors One Coat Lacquers – Dry time three minutes each side
Testors Enamel Spray -- Dry time 15 minutes each side
