Geometric Braid Bracelet
- Paracord – Yellow
- Bead Landing™ Color Pop™ Prism Charms
- Bead Landing™ Clasp – Silver
- Bead Landing™ Jump Rings – Silver
- Wire Cutters
- Round Nose Pliers
- Chain Nose Pliers
- Low Heat Glue Gun
Step 1 Measure the paracord around your wrist and add extra length for braiding. Cut the paracord with wire cutters. Repeat this step five more times so that you have six strands of paracord.
Step 2 Using three strands of paracord from Step 1, braid the entire strand. Repeat for the remaining three strands of paracord.
Step 3 Using the braids from Step 2, slip a jump ring on one end fold over the paracord so that it will hold the jump ring. Where the paracord folds over, add a small drop of hot glue and hold until secure. Repeat this step with the second end of the paracord.
Step 4 Repeat Step 3 using the second paracord braid.
Step 5 Gather the Color Pop™ prism charms. Remove the jump ring from one of the prism charm purple ends, open the jump ring from the other purple end and attach the two charms with this jump ring. See photo for reference.
Step 6 Gather the prism charm from Step 5, six jump rings, and the paracord braids from Step 3 and 4. Lay out the prism charm with one paracord braid on each side. On the sides of the prism charm where there are jump rings attach another jump ring. Use this jump ring to attach the prism charm to the paracord braids on each side. At the bottom of each end of the prism charm add two additional jump rings. Attach the last jump ring to the jump ring at the end of the paracord braid. You now have a cuff design. Reference photo.
Step 7 Gather the Bead Landing™ silver clasp and jump rings. On one end of the cuff design, add two jump rings and the silver clasp. On the other end you can add a few more jump rings for an adjustable size if you like.