Step: 1

Necklace
Cut a 16½-inch length of purple Beadalon 7 and chain.

Step: 2

Cut a 7-inch length of purple Beadalon 7 and pass it through the center link on the 16½-inch piece of chain.

Step: 3

Hold the wire ends together and pass them through a silver crimp bead. Adjust the wires so one is 3-inches long and one is 4-inches long. Push the crimp bead toward the fold to create a small loop.

Step: 4

Crimp the crimp bead and place a crimp cover over it. Use a crimping tool to close the cover.

Step: 5

Pass the 3-inch wire end through a purple shell chip, silver rondelle, green lentil and silver crimp bead. Crimp it. Attach a crimp cover.

Step: 6

Pass the 4-inch wire end through a purple shell bead frame with an 8mm black bead inside and a crimp bead. Crimp it. Attach a crimp cover.

Step: 7

Cut a 2½-inch length of bronze Beadalon 7. Pass the wire through a copper crimp bead, the next link on the 16½-inch chain and back into the crimp bead. Crimp it.

Step: 8

Pass the wire end through a 6/0 bead, silver rondelle, purple millefiori square and silver crimp bead. Crimp it and attach a crimp cover.

Step: 9

Pass a head pin through a square shell bead, silver rondelle, gray rondelle and 15 silver #0 crimp beads.

Step: 10

Make a basic loop to attach the head pin to the next link on the 16½-inch chain. Click to see technique for making loop.

Step: 11

Pass a head pin through a gray shell bead frame with two blue chips inside and 20 silver #0 crimp beads.

Step: 12

Make a basic loop to attach the head pin to the cable chain on the other side of the center dangle from step 2.

Step: 13

Attach a pinch bail to an 8mm purple glass bead.

Step: 14

Cut a ½-inch length of chain. Open the last link on the chain and attach it to the loop on the pinch bail.

Step: 15

Open the top link on the chain and attach it to the next link on the 16½-inch chain.

Step: 16

Cut a 16½-inch length of purple Beadalon 7 and pass it through the beaded dangles hanging from the center of the chain.

Step: 17

Add purple seed beads to each end of the purple beading wire.

Step: 18

Open the rings on the EZ-Crimp ends and remove them from the clasp attachment. Use a crimping tool to attach half of the clasp to each end of the beading wire.

Step: 19

Open a jump ring and use it to connect one end of the seed bead wire and one end of the 16½-inch chain. Attach it to half of the clasp. Repeat this step for the other end of the necklace.

Step: 20

Earrings
Pass an eye pin through one hole on a shell bead frame, two shell chips and the other hole on the bead frame. Make another loop.

Step: 21

Cut a ½-inch piece of chain and attach it to one of the loops on the eye pin.

Step: 22

Attach a pinch bail to the 8mm bead.

Step: 23

Open the last link on the chain and attach it to the loop on the pinch bail.

Step: 24

Attach the upper loop on the eye pin to the ear wire.

Step: 25

Repeat steps to make a matching earring.