Glam Josephine Knot Necklace
- Paracord – Pink
- Bead Landing™ Color Pop™ Pendant – Sliced Agate
- RSVP Rhinestone Bracelet
- Bead Landing™ Rhinestone Chain
- Bead Landing™ Pendant Hook
- Bead Landing™ Cord Clasp
- E-6000® Glue
- Chain Nose Pliers
- Wire Cutters
Step 1 You will need one cord, at least 24" long. Locate the center of the cord. Make a counter-clockwise loop with the left half of it. Be sure you bring the end under to make the crossing point on the left.
Step 2 Bring the right end down, passing across the center of the first loop, so it rests on top of the first loop. This creates a second loop. Before moving on to the next step, pass the right end under the left.
Step 3 Bring the right end up to the top of the knot, rotating clockwise. Direct it through the first two loops, weaving over - under - over - under as shown. This creates the third loop.
Step 4 Balance and tighten the knot so that loop two is at the top, with the ends at the bottom. Make sure to leave a small loop at the top, as pictured, to hang pendant.
Step 5 Repeat Steps 1-4, three times, creating three Josephine knots.
Step 6 Measure remaining paracord around your neck and trim to desired length.
Step 7 Gather the RSVP rhinestone bracelet, and using your wire cutters, clip between the rhinestones to separate the bracelet, making a single strand of stretchy rhinestones.
Step 8 Gather the Color Pop™ sliced agate pendant and outline the silhouette with E-6000® glue. Using the rhinestone strand from Step 5, cover the E-6000® glue on the outside of the pendant and hold tightly until adhered. Clip excess rhinestones using wire cutters. Let rhinestones dry completely on pendant.
Step 9 Gather the Bead Landing™ cord clasp. Open one end of the latch and insert a drop of E-6000® glue. Then insert one end of the paracord and close the latch and hold tightly until paracord is adhered to clasp.
Step 10 Repeat Step 9, using the other end of the cord clasp and paracord.
Step 11 Using E6000 glue, draw a thin line on top of the access paracord from where the Josephine Knot ends to the cord clasp on each side.
Step 12 Gather the Bead Landing™ Rhinestone chain and cover the E-6000® glue from where the Josephine knot ends to the cord clasp on each side. Let dry until rhinestones are adhered to paracord.
Step 13 Attach the Bead Landing™ pendant hook to the Color Pop™ sliced agate pendant from Step 8 and to the paracord loop from Step 4.