Formulated to create a permanent bond between slick surfaces like glass and plastic, this quick-setting, high-performance adhesive is great for jewelry, metal and shell crafting. Recommended for: Glass, beads, mirrors, ceramics, hard plastics, and jewelry.

COMMONLY USED SURFACE-TO-SURFACE APPLICATIONS ARE:

•  Beads, Jewelry, Glass, Ceramics - Glass

DIRECTIONS FOR USING ALEENE'S GLASS & BEAD™ ADHESIVE:

1. Thoroughly clean and dry surfaces, including decorative elements, making sure they are free of oil and grease.
2. Apply a small amount of adhesive to the surface and to the decorative element. Position decorative element in adhesive on surface.
3. For rounded surfaces, it may be necessary to tape decorative elements in place until dry to prevent sliding.
4. To ensure a maximum-strength bond, let adhesive set approximately 1-2 minutes before joining surfaces. 
   

SPECIAL TIPS: Test before use. Not intended for plastics. May affect the appearance of plastic rhinestones.

TEMPERATURE RECOMMENDATIONS/LIMITATIONS: Performs best when applied at room temperature.

CURE RATE & DRYING TIME: Set in 10 to 15 minutes. Dry in 24 hours.

CLEAN UP & REMOVAL RECOMMENDATIONS: Warm soapy water before dry.

CAUTION ADVISORIES OR SAFETY RECOMMENDATIONS: Strong fumes - use in well ventilated areas, avoid exposure to skin, keep away from heat and do not use near open flame. Not recommended for Fabric.