Gold Druzy Macramé Bracelet
- Bead Gallery® Acrylic Druzy Bead - Gold-tone
- Bead Gallery® Metal Strung Beads
- Bead Landing™ Hemp Cord, 20 lb.
Step 1 Cut the hemp cord into one 20" strand and one 60" strand. Fold the short cord in half and tape the fold onto a working surface. Center the long cord under the two middle strands. Fold the right cord over the middle strands and under the left cord.
Step 2 Pull the left cord under the right and middle strands and through the loop on the right side. Pull tightly and slide the knot up to create a small loop.
Step 3 Continue the square knot by folding the left cord over the middle strands and under the right cord. Pull the right cord under the left and middle strands and through the loop on the left side.
Step 4 Pull tightly and repeat the steps – left, right, left, right. Stop knotting at the halfway point.
Step 5 Thread the Bead Gallery® gold-tone acrylic druzy bead onto the two middle strands. Continue knotting. Measure the bracelet around the wrist to check the fit. From the first knot to the last, the fit should be rather tight.
Step 6 To finish the bracelet, tie a knot with all strands. Thread the Bead Gallery® metal strung beads with all strands. Now tie another knot with all strands and trim excess cording to desired length.