Golden Fire Bracelet
Get fired up over red, orange, and yellow Crystazzi® Crystals.
- Crystazzi® Bicone, 4mm – Black, Dark Purple, Dark Siam, Red Topaz and Topaz
- Gold Elegance® Oval Necklace, 8" (2-Pk.)
- Gold Elegance® Eye Pins (3-Pk.)
- Gold Elegance® Open Jump Rings, 4mm (3-Pk.)
- Gold Elegance® 3-Strand Rod Clasp
- Gold Elegance® Eye Pins, 2½"
- Plated Silver Elegance™ Charm – Cross
- Round Nose Pliers
- Needle Nose Pliers
- Wire Cutters
Cut (2) nine-link and (4) two-link sections of chain.
Step 2 Link (7) 4mm jump rings together, then repeat this three more times, creating a total of (4) seven-link jump ring sections.
Connect a two-link section to one end of each jump ring linked section.
Make (16) topaz/red topaz/Dark Siam bicone links.
Attach a beaded link to each link of the nine-link chains, leaving the center chain link empty.
Connect the other end of the beaded links to a jump ring on a jump ring section. The first four beaded links along the nine-link chain will connect to every other jump ring along one seven-link jump ring section. The next four beaded links along the nine-link chain will connect to every other jump ring along a second seven-link jump ring section. Repeat until all beaded links are connected to jump rings.
Make (4) dark purple bicone links. Attach a link to the end of each seven-link jump ring section.
Make (8) black/purple/black bicone links.
Use the black/purple bicone links to connect the jump ring sections. The links should connect to the same jump rings that the topaz/red topaz/Siam bicones are linked to.
Make (2) red topaz/Siam bicone links. Connect each beaded link to the center link of each nine-link chain section.
Connect the cross charm to the red topaz/Siam bicone links and the purple bicone links. Use 4mm jump rings to connect the cross charm to the black/purple/black bicone links.
Cut (2) four-link sections of oval chain.
Using 4mm jump rings, attach the four-link chain ends to one end of each nine-link chain.
Using 4mm jump rings, attach the two-link chains to the middle links of the four-link sections of chain.
Thread a 2½" eye pin through the small links of a four-link chain section. Attach the loop end to the jump ring at the end of the chain. Form a loop at the other end (approximately 1¼" up the shaft of the pin) and attach to the other jump ring at the end of the chain. Repeat this step for the second eye pin and the second section of four-link chain. (This will keep the four-link chain straighter while wearing the bracelet.)
Cut (6) three-link sections of oval chain.
Use 4mm jump rings to attach a three-link chain to each of the loops of the three-strand spacers.
Using 4mm jump rings, attach the three-link chain sections to the four-link chains.