Good Wishes Card
Use a hot glue gun to quickly adhere all the layers of flowers together and to the face of the card.
Instructions by Windy Robinson, courtesy of Spellbinders™ Paper Arts.
- Spellbinders™ Grand Calibur® Machine
- Spellbinders™ Die Template - Spiral Blossom One, Classic Squares Large
- Stamp - Gratitude Sentiment of Chioice
- 3D Foam Squares
- Pattered Paper, 6"x6"
- Pattered Paper, 12"x12"
- Tissue Paper - Purple
- Low Heat Glue Gun & Glue
To Make Card Base
Make card that measures 5"x5" with small Patterned Paper.
Cut/emboss patterned paper with Classic Square LG #7 (#1 being the smallest) using Spellbinders™ Grand Calibur® Machine.
Stamp sentiment in upper right hand corner of card.
Adhere square to face of card with 3D foam squares.
To Make Flowers
Take tissue paper and fold layers into a square that measures 5"x5". (Note: the more layers you include in your stack the fuller your flower will become).
Tape Spiral Blossom One die template to square of tissue paper. Cut/emboss flower.
Pull stack of tissue flower dies from die template. Keep all layers together.
Roll spiral flower (all layers at once). Allow layers of tissue to unwrap to make multi-layer petals.
Adhere each layer with a drop of hot glue.
Repeat three times to create three flowers, and adhere each flower to card.