Project Instructions

Make a spiral curl using the round nose on all enameled head pin in red.  

Create one hole using a punch tool on the middle most, back part of one ring shank. Insert one curled enameled head pin through the hole made going from the inner to the outer part of the ring. Make loop on the inserted headpin wire end.  

Attach charms from Set 1 in the materials section to the domed cup, front end of the ring using one jump ring. This will now be called Ring Charm 1.  

Connect Ring Charm 1 to the left most bracelet chain link using one jump ring. Secure position by inserting one curled enameled headpin in green through the chain link and ring charm.

Repeat Steps 1-4 using the charms by set until you have completed all 5 sets. Each set will be referred to as Ring Charms so that Set 2 will now be called Ring Charm 2.  

Note: Ring Charm 1 should be on the left most bracelet chain link and Ring Charm 5 should be on the right most bracelet chain link.  

Connect one toggle clasp on each bracelet chain end.  

Attach leather cords on each toggle end. The leather cord can also be substituted by any of the Industrial Chic™ chains.