"Just Married" Banner
Use this modern banner to spice up the get-away car for the bride and groom; it will be one they will keep around for years to come.
Designed by Kathy Dobson, courtesy of DCWV®.
- DCWV® Paper Stack, 12"x12" – Bella Armoire
- Silk Ribbon, 3/8" – Pink
- Ruffled Ribbon, 1¼" – Pink
- Sheer Ribbon, 38/" – Pink
- Low Heat Glue Gun and Glue Sticks
- Scoring Tool
- Paper Trimmer, 12"
- Pattern (download button below)
Choose your desired prints for the banner. You will need at least six for the hearts, two for the flower and two for the main section of the banner.
Print out the pattern below. Cut them out and keep them close by.
Measure the space of the vehicle and cut pink silk ribbon, allowing enough space at the ends to attach the banner.
Take your prints for the banner hearts and score and fold them down the middle. Line the top of the template up with the fold and trace around it. Cut around your tracing lines only (the top of the heart folds over the banner ribbon). Repeat for remaining hearts.
Print out Just Married in a lighter print. Cut off excess paper and round the corners in. Mount this in the center of a larger piece of contrasting printed paper. Cut around the outside, leaving a thin border (up to ½"), and following the lines of the first sheet. Adhere this to the center of the ribbon.
Before adding the hearts, tie two large bows to the banner, one to each side of the main section in the middle. Now, fold the tops of the hearts over the ribbon and adhere in place. Embellish with more ribbon and flowers.