- Aleene’s® Glue OK to Wash-It®
- Aleene’s® Glue Jewel-It
- Tulip® Soft™ Brushable Fabric Paint, Ebony Matte
- Sweatshirt, red
- Foam visor, red
- Hole punch
- Pipe cleaners, black
- Pom-Poms, black
- Ribbon, black polka dot
- Tracing paper
- Tulle by the Yard, Light Pink
- Aluminum foil
Cut out wing pattern and place on tulle. Pin in place if needed. Cut out wing. Repeat to create four wings. Set aside.
Using chalk, mark placement for dots on the sweatshirt.
Squeeze a small amount of Soft Paint onto foil. Use paint brush to fill in dots with Soft Paint. Repeat process for visor.
Squeeze a small amount of glue onto foil. Brush glue onto ribbon. Apply ribbon vertically down the center of the sweatshirt just below neckline.
Tie another piece of ribbon into a bow and glue to the top of the vertical strip of ribbon.
Wrap pipe cleaners around one of your fingers and gently stretch to make it long again.
Hole punch two holes on the top of the visor. Feed a pipe cleaner through each of the holes and twist ends to attach to visor.
Apply a bit of glue to the top of the each of the pipe cleaners and adhere black pom-poms.
Cut two 1-inch long pieces of dotted ribbon, trimming the ends at a diagonal to make a point. To create one wing, layer two pieces of tulle and twist ends. Glue twisted end of tulle under the pointed end of the ribbon. Repeat for remaining wing.
Glue wings to tops of shoulders just below neckline.
TipsRefer to photo to complete project.
Follow manufacturer's direction for products used.