Locker Accessory (Dry Erase & Mirror)
Add to Favorites Print

Locker Accessory (Dry Erase & Mirror)

This locker accessory will do double duty by keeping you organized on one side, and primped and ready on the other!
Age Range: 9-12
Craft Time: 60+ minutes
Messy Rating:
1 2 3 4 5
Uses Recycled Items: No
 
 
 
 
Get exclusive offers about this product and more!
 
 

Material List

  • Elmer’s® Dry Erase Foam Board, 20"x30" – White
  • Elmer’s® Designer Masking Tape
  • Elmer’s® 3D Swirl Glam Glitter Glue
  • Elmer’s® Double Sided Permanent Tape
  • Elmer’s® Painters Markers
  • Cutting Mat, 12"x12"
  • X-ACTO® Designer Series Gripster® Craft Knife
  • Scissors
  • Ruler
  • Dry Erase Marker
  • Foam Sheet Self-Adhesive, 8½"x11" – Color of Choice
  • Ribbons, 3/8"x1/8"
  • Circular Mirror, 5"
  • Foam Letter Stickers (Optional)
 

Project Instructions

Step 1 Place one Elmer’s® Dry Erase Foam Board on cutting work surface. Use X-ACTO® Designer Series Gripster® Craft Knife and Ruler to measure and cut a 6"x8" piece from a 20"x30" Foam Board sheet.

Step 2 Use a Gripster® Craft Knife and Ruler to measure and cut a 6"x8" piece of self-adhesive foam.

Step 3 Cut a piece of 3/8" ribbon 24" long with Scissors and fold in half. Sandwich in between the cut Foam Board and self-adhesive foam sheet (remove white protective covering from foam sheet to reveal adhesive). Make sure to leave a loop of approximately 6" at the top to create your hanger for your locker accessory.

Step 4 Use Elmers® Double Sided Permanent Tape and run strips all along the back of your mirror. Remove white protective covering on tape and adhere the mirror to the center of the foam side of your accessory board.

Step 5 Run a strip of Elmers® Designer Masking Tape across the front (along the top and bottom edge of your mirror) from edge to edge of your board. It can wrap along the edges of your board, but do not wrap around to the dry erase side. Cut two 8" lengths of Designer Masking Tape and run them along each side edge covering up the exposed Foam Board edges on the sides. Continue by adding more lines of Decorative Tape along the edges on the mirror side of your locker accessory frame.

Step 6 On the dry erase exposed side, run more Decorative Tape all along the top, bottom, and sides to frame your board.

Step 7 Decorate the front of your mirror accessory side with Painters Markers and Swirl Glam Glitter Glues. Let dry completely.

Step 8 Decorate the barrel of your dry erase marker with stripes of Decorative Masking Tape to coordinate with your board.

Step 9 Cut a length of 12" from 1/8" ribbon and tie one end on the cap of your dry erase marker. Tie the other end on the ribbon handle at the top to secure.

Step 10 Personalize your board by placing foam letter stickers on the front and back of your locker accessory board.

Craft Notes

Crafted for Michaels by Elmer's Products