Lucky Lucky Necklace
Add to Favorites Print

Lucky Lucky Necklace

Add a horseshoe for good luck!

Designed by Barb Switzer.

Uses Recycled Items: No
 
 
 
 
Get exclusive offers about this product and more!
 
 

Material List

  • Slider - Horseshoe
  • Artistic Wire, 20 gauge – Non-tarnish Brass (2")
  • Oval Link Chain – Antique Brass
  • Lobster Clasp – Antique Brass
  • Jump Rings, 4mm – Antique Brass (2)
  • Flush Cutters
  • Round Nose Pliers
  • Chain Nose Pliers (2)
 

Project Instructions

Cut two ¾" pieces of 20 gauge wire, making sure to flush cut both ends on each piece. Using round nose pliers, form a loop on one end. Repeat on the other end of the wire, turning the loops in opposite directions to form a figure-8 shaped link. Repeat on the remaining piece of 20 gauge wire.

Open a loop on both figure-8 links. Attach through the hole on the ends of the horseshoe slider, and then close the figure-8 link again. Repeat on the opposite end of the slider, adding a total two figure-8s to the slider.

Open a chain link on an 7½" section of chain. Attach the link to the figure-8 link attached to the horseshoe slider, and then close the chain link again. Repeat on the opposite side with a second 8" section of chain.

Using the lobster clasp included in the chain pack, attach each half of the toggle clasp to the end links of the chain sections with a single brass jump ring.