Lucky Lucky Necklace
Add a horseshoe for good luck!
Designed by Barb Switzer.
- Slider - Horseshoe
- Artistic Wire, 20 gauge – Non-tarnish Brass (2")
- Oval Link Chain – Antique Brass
- Lobster Clasp – Antique Brass
- Jump Rings, 4mm – Antique Brass (2)
- Flush Cutters
- Round Nose Pliers
- Chain Nose Pliers (2)
Cut two ¾" pieces of 20 gauge wire, making sure to flush cut both ends on each piece. Using round nose pliers, form a loop on one end. Repeat on the other end of the wire, turning the loops in opposite directions to form a figure-8 shaped link. Repeat on the remaining piece of 20 gauge wire.
Open a loop on both figure-8 links. Attach through the hole on the ends of the horseshoe slider, and then close the figure-8 link again. Repeat on the opposite end of the slider, adding a total two figure-8s to the slider.
Open a chain link on an 7½" section of chain. Attach the link to the figure-8 link attached to the horseshoe slider, and then close the chain link again. Repeat on the opposite side with a second 8" section of chain.
Using the lobster clasp included in the chain pack, attach each half of the toggle clasp to the end links of the chain sections with a single brass jump ring.