Marguerite Masquerade Martini Glass
Designed by Chris Thornton for Delta Creative®
Material List
- Delta Creative® Air-Dry PermEnamel™ Tangerine
- Delta Creative® Air-Dry PermEnamel™ Ultra White
- Delta Creative® Air-Dry PermEnamel™ Royal Purple
- Delta Creative® Air-Dry PermEnamel™ Crocus Yellow
- Delta Creative® Air-Dry PermEnamel™ Surface Conditioner
- Large Martini Glass
- Loew-Cornell® Acrylic Handle Glaze Series 7550C, No. 1-inch
- Loew-Cornell® Acrylic Handle Round Series 7000C, No. 3
- Loew-Cornell® Acrylic Handle Liner Series 7350C Size No. 0
- Loew-Cornell® Seawool Sponge
- Palette
- Transfer Paper
- Tracing Paper
- Water Container
- Paper Towel
- Scissors
Project Instructions
Step: 1
Working With PermEnamel
Do not apply PermEnamel™ products within ¾-inches of any area that may come in contact with food.
Be sure to allow a little extra drying time between coats with PermEnamel™. It may feel dry to touch but has not bonded with glass yet. If you don’t allow the first coat enough time to bond, the color will slip and slide, making a mess.
Because glass is non-porous, it will take more coats for opaque coverage.
PermEnamel™ will air-dry to touch in a few minutes. When air-dried for 10 days, PermEnamel™ is cured and is dishwasher, microwave, and oven (3 up to 350 degrees F.) safe.
Do not use water with PermEnamel™ . Water will break down the properties of the paint. Only use water for cleanup. When floating, use either Thinner or Retarder. My personal favorite is a mix of 3 parts Gloss Glaze to 1 part Thinner.
Step: 2
Preparation
Wash painting surface with warm soapy water. Allow to dry.
Step: 3
Using the 1-inch glaze brush, apply very liberal coat of Surface Conditioner. The PermEnamel™ Surface Conditioner is extremely important for this technique! It creates the bond between the glass and the color. Surface Conditioner will leave a milky look on glass. When the milky look appears, begin painting. A thin coat must be reapplied every 4 hours. You may apply the conditioner right over painted areas.
Step: 4
Basecoat top Crocus Yellow leaving 1-inch clear band at lip.
Step: 5
Using seawool sponge, pick up small amount of Tangerine, pat on palette to remove excess, then pat on glass starting at top and working down about 2/3 of the way.
Step: 6
Repeat process with seawool sponge using Royal Purple + a touch of Ultra White, working down glass about 1/3 of the way.
Step: 7
Transferring Pattern
Lay tracing paper over pattern. Trace all lines. Lay tracing on surface, and tape in place. Slide graphite paper between tracing and surface, draw over main lines.
Step: 8
Basecoat stem of glass, do branches, moon and bats all in Ultra Black using Liner Brush Size No. 0.
Step: 9
Allow to cure for 10 days.
Tips
Refer to photo to complete project.
Follow manufacturer’s direction for products used.
If you have never worked with PermEnamel™ be patient, it’s a lot of fun to work with.

