Project Instructions

Step 1 Wash ornaments in warm soapy water; rinse well and allow to dry.

Step 2 Moisten paper towel with rubbing alcohol; wipe ornaments to remove any residue. Allow to dry.

Step 3 Peel adhesive stencil from backing sheet; set backing aside and save for storage.

Step 4 Position adhesive stencil on surface where desired; press in place.

Step 5 Squeeze a small amount of paint onto foam plate.

Step 6 Load the flat edge of the pouncer by dabbing into the puddle of paint.

Step 7 Holding the foam pouncer like a pencil, dab straight up and down over the stencil opening. Continue until the entire design area has been painted.

Step 8 While paint is still wet, carefully remove stencil.

Step 9 Continue adding stenciled designs until desired effect is achieved. NOTE: When repeating a design, clean the stencil between uses by rinsing in water and allowing to dry thoroughly.

Step 10 To add depth to your ornament, apply a coat or two of desired paint color to back of ornament. Allow paint to dry between coats.

Step 11 If desired, add a stenciled design on the back of the ornament.

Step 12 Embellish snowflake designs with small dots of paint. Use either a paintbrush handle dipped in paint or apply dots directly from the bottle tip. If desired, apply flat back pearls or gems when paint is dry.