Bead Landing™ Metal Mania Wheel of Fortune Necklace
Add to Favorites Print

Bead Landing™ Metal Mania Wheel of Fortune Necklace

Metal components give this necklace an industrial feel, while the beads make it elegant.

Designed by Margaret Pankhurst

Craft Time: 30 minutes
Uses Recycled Items: No
 
 
 
 
Get exclusive offers about this product and more!
 
 

Material List

  • Bead Landing™ Metal Mania™ Pendant
  • Bead Landing™ Metal Mania™ Grid Pendant
  • Bead Landing™ Metal Mania™ Chain
  • Bead Landing™ Chain
  • Bead Gallery® Beads
  • Bead Gallery® Disk Bead, Large
  • Flexible Beading Wire
  • Jump Rings
  • Wire Cutters
  • Crimp Tubes
  • Crimp Tubes with Loops
  • Wire, 22ga
  • Crimping Pliers
  • Bent Nose Pliers
 

Project Instructions

Wire beads to the front of the pendant using the 22ga wire.   

Attach a jump ring to the top of the pendant. 

Cut three 9" lengths of flexible beading wire.  

Feed one end of each wire up through a crimp bead and back down through it leaving a small loop. Crimp the tube tightly with crimp pliers to secure the wire in the tube.  

Place enough beads on each wire to make a 6" length.   

On the end feed the wire up through a crimp bead and back down through it leaving a small loop. Crimp the tube tightly with crimp pliers to secure the wire in the tube.  

Attach a jump ring to each end of all the beaded strands.    

Before closing the jump rings, attach one to each of the 3 connections on the Bead Landing™ grid pendants.  

Weave the Bead Landing(TM) chain through the jump ring and around the strands of beads. Secure the ends onto a jump ring.  

Divide the Bead Landing™ Metal Mania™ chain into two 7" lengths.  

Wire four flat large beads to the center of the large circular links with wire. 

Cut four lengths of flexible beading wire.  

Feed one end of each wire up through a crimp bead and back down through it leaving a small loop. Crimp the tube tightly with crimp pliers to secure the wire in the tube.  

Bead each length with beads until two lengths are 6" long and two are 7" long.  

Feed the end of each wire up through a crimp bead and back down through it leaving a small loop. Crimp the tube tightly with crimp pliers to secure the wire in the tube.  

Attach a jump ring to each end of the beaded lengths.  

Before closing the jump rings attach them to the outside edge of the pair of Bead Landing™ grid pendants.  

Place the opposite ends of all three lengths of beaded chain onto one 8mm jump ring.  

Repeat for the other side of the necklace.  

Before closing the jump ring, place a lobster claw onto the jump ring. Close the jump ring securely with bent nose pliers.

Tips

Refer to photo for project details.