Step: 1

Cut patterns apart.

Step: 2

Pin body pattern to two layers of green felt and cut out. Remove pattern.

Step: 3

Center head pattern on shortest edge of body pattern and tape together. Pin pattern to stiff blue felt and cut out. Remove pattern.

Step: 4

Pin remaining patterns to felt, following pattern instructions for number and colors then cut each out. Leave pattern on felt until needed.

Step: 5

Remove pattern for arms and legs then position on blue felt body where shown, adjusting as needed. Pin in place.

Step: 6

Place two layers of green felt for body on top of blue felt piece, sandwiching arms and legs and lining up edges, and pin in place.

Step: 7

Use sewing machine to sew along two sides and bottom edge, sewing arms and legs in place. Remove pins.

Step: 8

Cut a ½” x 3” piece of blue felt. Use Fabric Fusion™ to glue to back of red antennae piece - this will allow it to stand up. Set aside to dry.

Step: 9

On computer, determine desired font and size needed for name and print out. Cut out each letter, pin to red felt and cut out.

Step: 10

Referring to photo for placement, place all felt shapes in place. Lime “ear” pieces and antennae are placed behind head. Apply thin beads of Fabric Fusion™ to back of pieces and press in place.

Step: 11

Cut silver ribbon to fit across legs and arms adding an extra 2” at both ends. Add a thin bead of Fabric Fusion™ on felt then lightly press ribbon into place. Let dry then flip over and glue ends in place.

Step: 12

Working on a few lines at a time, add a thin bead of Fabric Fusion™ for silver cording on mouth and dial. Press cording into glue then trim ends. Continue with all cording and let dry.

Step: 13

Glue flat glittery discs from button package in place where shown. Let dry.

Step: 14

Use hole punch to punch a hole about ½” in from edge on each corner of head. Cut a 16” length of cording. Tie a knot in one end then thread untied end through hole, determine length of hanger then thread through other hole. Knot end of cording then trim end.