Patina Textured Pot
Adding a patina finish to this textured pot gives it a rich and beautifully aged appearance.
- Large Clay Pot
- Sophisticated Finishes:
Metallic Surfacer: Copper
Antiquing Solution: Patina Green
- Texture Magic Dimensional Paint: White
- Texture Magic Tool Kit
- Stencil of choice
- Painters Tape
- Wilton® Squeeze Bottle (2)
- Plastic Gloves
- Foam Brushes
- Disposable Plate
- Paper Towels
- Mixed Fern/Grass Bushes, 2
- Ivy Bush
- Wire Cutters
- Floral Foam
- Craft Knife
- Glue Gun and Glue Sticks
Read through all manufacturer’s instructions before starting project.
Cut desired design from stencil and tape onto pot.
Follow directions on Texture Magic and apply to stencil, pull off stencil leaving design. Set aside to dry thoroughly.
Paint entire pot with Copper Surfacer, let dry 24 hours.
Tape off design area so that tape will keep the antiquing from running onto pot area outside of design.
Paint Copper Surfacer onto design area and immediately pour on Antiquing Solution. Prop pot so that the antiquing will not run out of taped area onto pot. Let dry.
Remove tape and repeat for other designs on pot.
While pot is upside down on paper towels, paint rim of pot with Copper Surfacer and immediately pour Antiquing Solution on edge.
Tip: The antiquing time will very. If the desired effect is not achieved, paint over with Copper Surfacer and start again. Seal if desired. Let dry completely.
Cut floral foam to fit inside pot and glue in place. Cut apart greenery bushes and insert into floral foam as shown.
Use photo as a guide and follow manufacturer’s instructions for all products used.