Patina Textured Pot
Add to Favorites Print

Patina Textured Pot


Adding a patina finish to this textured pot gives it a rich and beautifully aged appearance.
Craft Time: 60+ minutes
Uses Recycled Items: No
 
 
 
 
Get exclusive offers about this product and more!
 
 

Material List

  • Large Clay Pot
  • Sophisticated Finishes:
    Metallic Surfacer: Copper
    Antiquing Solution: Patina Green
  • Texture Magic Dimensional Paint: White
  • Texture Magic Tool Kit
  • Stencil of choice
  • Scissors
  • Painters Tape
  • Wilton® Squeeze Bottle (2)
  • Plastic Gloves
  • Foam Brushes
  • Disposable Plate
  • Paper Towels
  • Mixed Fern/Grass Bushes, 2
  • Ivy Bush
  • Wire Cutters
  • Floral Foam
  • Craft Knife
  • Glue Gun and Glue Sticks
 

Project Instructions

Step: 1

Read through all manufacturer’s instructions before starting project.


Step: 2

Cut desired design from stencil and tape onto pot.


Step: 3

Follow directions on Texture Magic and apply to stencil, pull off stencil leaving design. Set aside to dry thoroughly.


Step: 4

Paint entire pot with Copper Surfacer, let dry 24 hours.


Step: 5

Tape off design area so that tape will keep the antiquing from running onto pot area outside of design.


Step: 6

Paint Copper Surfacer onto design area and immediately pour on Antiquing Solution. Prop pot so that the antiquing will not run out of taped area onto pot. Let dry.


Step: 7

Remove tape and repeat for other designs on pot.


Step: 8

While pot is upside down on paper towels, paint rim of pot with Copper Surfacer and immediately pour Antiquing Solution on edge.


Step: 9

Tip: The antiquing time will very. If the desired effect is not achieved, paint over with Copper Surfacer and start again. Seal if desired. Let dry completely.


Step: 10

Cut floral foam to fit inside pot and glue in place. Cut apart greenery bushes and insert into floral foam as shown.


Tips

Use photo as a guide and follow manufacturer’s instructions for all products used.