Step: 1

Read through all manufacturer’s instructions before starting project.

Step: 2

Cut desired design from stencil and tape onto pot.

Step: 3

Follow directions on Texture Magic and apply to stencil, pull off stencil leaving design. Set aside to dry thoroughly.

Step: 4

Paint entire pot with Copper Surfacer, let dry 24 hours.

Step: 5

Tape off design area so that tape will keep the antiquing from running onto pot area outside of design.

Step: 6

Paint Copper Surfacer onto design area and immediately pour on Antiquing Solution. Prop pot so that the antiquing will not run out of taped area onto pot. Let dry.

Step: 7

Remove tape and repeat for other designs on pot.

Step: 8

While pot is upside down on paper towels, paint rim of pot with Copper Surfacer and immediately pour Antiquing Solution on edge.

Step: 9

Tip: The antiquing time will very. If the desired effect is not achieved, paint over with Copper Surfacer and start again. Seal if desired. Let dry completely.

Step: 10

Cut floral foam to fit inside pot and glue in place. Cut apart greenery bushes and insert into floral foam as shown.