Rainbow Bullseye Tee
You’ll hit a creative bullseye with Tulip® One-Step Fashion Dye™! Create this vibrant t-shirt with rubber bands and a splash of color.
Designed by Cheryl Ball, courtesy of iLoveToCreate™, a Duncan Enterprises Company
- Tulip® One-Step Fashion Dyes™: Yellow, Red, Violet, Blue, Green
- White T-Shirt
- Rubber Bands or Zip-Ties
- Plastic Tablecloth
Wash shirt in washer to remove sizing.
Cover work surface with plastic tablecloth.
Place damp shirt on prepared surface and smooth flat. To create bullseye design, pinch front of shirt just above center then lift fabric up and scrunch fabric into a tube shape. Wrap a rubber band about 2-inches from tip, wrapping several times until tight. If using zip-ties, determine placement then wrap and pull tightly. Repeat every 2-inches or so along entire shirt.
Wearing gloves from dye box, fill a dye bottle half with water. Replace cap and shake until all dye is thoroughly mixed. Remove lid, add more water to line indicated on bottle, replace cap and shake to mix.
Carefully squeeze Yellow dye on tip, turning shirt until entire tip has dye.
Squeeze Red dye around center of next section, letting it bleed toward rubber bands. Insert tip of bottle into folds and squeeze more dye as needed. Note: Try not to squeeze too much dye next to rubber bands to keep white areas between colors. Squeeze dye on in the following order: Yellow, Red, Violet, Blue, Green then repeat colors.
Let set 4 to 6 hours. Use scissors to carefully cut off rubber bands or zip ties.
Fill washer to a full load setting with a small amount of laundry soap. Once agitation starts, insert shirt. Dry in dryer or line dry.
Use photo as a guide and follow manufacturer’s instructions for all products used.
Use pointed scissors to cut off rubber bands or zip ties - the points get under the rubber bands easier and make it easier to cut. Be sure not catch fabric when cutting.