Silver Bracelet & Earrings
This matching set will go great with any ensemble.
Designed by Michaels Jewelry Instructor: Gabriella Girgenti.
- Wire Guardians
- Wire Hooks
- Crimp Beads
- Crimp Covers
- Beading Wire
- Beads, 6mm – Crystal
- Bicones, 4mm – Crystal
- Cylinder Wire Spacers
- Lobster Clasp
- Jump Ring
- Flat Nose Pliers
- Round Nose Pliers
- Wire Cutters
- Crimp Pliers
Step 1 Cut a 1' length of wire and center a 6mm crystal bead.
Step 2 Add one 4mm crystal bicone on either side of crystal bead.
Step 3 Add one long cylinder spacer on either side of bicone beads.
Step 4 Add one 4mm crystal bicone to one side only, and thread the beading wire on the opposite side through the bicone bead.
Step 5 Thread crimp bead through both beading wires, add wire guardian and earring hooks; double back to make a loop, crimp the crimp bead with crimping pliers.
Step 6 Attach crimp cover to crimp bead with crimping pliers.
Step 1 Cut 3' length of beading wire and center a 6mm crystal round bead.
Step 2 Add one 4mm bicone bead to either side of round bead.
Step 3 Add one cylinder bead spacer on either side of crystal bicone beads.
Step 4 Add another 4mm crystal bicone bead, 6mm bead, 4mm crystal bicone bead on one side of beading wire and thread beading wire from opposite end through the same three beads.
Step 5 Repeat Steps 2-4 until you have the desired length.
Step 6 End with crystal beads and thread both beading wire ends through a crimp bead, add wire guardian and then lobster clasp; double back to make a loop, crimp the crimp bead with crimping pliers.
Step 7 Add crimp covers to crimp bead and close with crimping pliers.
Step 8 Repeat same steps for other side, except attach a jump ring instead of a lobster clasp.