Sitting Pretty Place Card Holder or Napkin Ring
- Split Rings, 32mm (4)
- Craft Wire, 20 ga. – Gold-plated (336")
- Glass Faceted Rounds, 14mm – Peridot (12), Crystal (12), Aqua (12) and Ruby (12)
- Chain Nose Pliers
- Round Nose Pliers
- Wire Cutter
Step 1 Cut 72 6" pieces of craft wire. Cut four 12" pieces of craft wire.
Step 2 Take a 6" piece of craft wire and make a wrapped loop about 2" from the end. String a
bead on the wire. Wrap the tail end of the wire around the outside of the bead and down
to the bottom, wrapping the end securely.
Step 3 Repeat Step 2 for the remaining glass rounds.
Step 4 Take a 12" piece of craft wire and bend in half gently. Wrap the wire once around the
split ring, opposite from the opening.
Step 5 String a round onto one side of the wire and wrap it around the split ring. String a round
onto the other side of the wire and wrap it round the split ring.
Step 6 Keep adding the rounds to the wire, wrapping the wire tightly around the split ring as you go.
Step 7 Wrap the ends around the split ring.
Step 8 Repeat for all four split rings.