Slotted 3D Wood Snowman
Material List
- 3D Wood – Snowman
- Acrylic Paint – White, Black and Light Blue
- Foam Brushes
- Creatology™ Wiggle Eyes, 25mm
- Creatology™ Pom Poms, ¼” – Black
- Creatology™ Chenille Stem – Orange Bump
- Bandana – Red
- Ink Pad – Red or Pink and Black (Optional)
- Sponge Dabber
- Scissors
- Low Heat Glue Gun
Project Instructions
Step 1
Paint the snowman white, and while still wet, brush some light blue along the edges. Blend in with the white. Let dry completely. Repeat with the other section of the snowman.
Step 2
Paint the hat black and let dry.
Step 3
If desired, use a sponge dabber to apply red or pink pigment ink to the cheeks. Use a circular motion to apply. You can also use a black ink pad along the edges of the snowman if desired.
Step 4
Glue on the eyes. Cut a section of orange bump chenille, bend in half and glue to the face for the nose. Glue on ¼" black pom poms for the mouth.
Step 5
Connect the two wood pieces of the snowman.
Step 6
Cut or tear a 1" wide section of a bandana for the scarf. Tie around the neck. Edges can be trimmed and frayed.
Step 7
Cut another section of the bandana. Wrap around the brim of the hat and glue in place.
