Sparkling Halloween Shirt
- Tulip® Sticky Fabric Stencils™
- Tulip® Fashion Glitter Bond™
- Tulip® Fashion Glitter™
- Black Fine
- Emerald Fine Jewel
- Purple Jewel
- Tulip™ Fashion Form ™
- T-shirt- Orange
- Masking Tape
- Scrap Paper
Prewash shirt to remove sizing. Do not use fabric softener in washer or dryer.
Cut hems off of sleeves and bottom of shirt. Place a strip of tape about 3” above cut edge at bottom. Cut up to tape edge about every 3/8” to create fringe. Repeat with sleeves but make fringe 2” long. Cut off ribbing at neck.
Place shirt on Fashion Form. Place skull stencil on center of shirt allowing for hat. Place a strip of masking tape at an angle about 1” down from top of skull. NOTE: Glitter will not be in this area. Always use masking tape along edges of stencil to make sure there is no overrun.
Squeeze a puddle of Glitter Bond on foil. Tap flat end of sponge in Glitter Bond and then in openings of stencil until covered. Immediately, sprinkle with black glitter. Let dry a few moments then shake excess glitter onto a paper and return to bottle. Remove stencil after a few minutes.
Repeat this process with bone stencil scattered over shirt. Sprinkle with purple glitter. Return excess to bottle.
Cut hat and broom stencil apart, close to bottom edge of hat brim. When skull is dry, lay hat stencil at an angle as close to skull as possible without disturbing black glitter. Apply Glitter Bond to opening being very careful along bottom edge and sprinkle with green glitter. Remove excess glitter. If there is a gap where the orange of the shirt shows between the hat and skull, apply Glitter Bond carefully with small end of sponge on skull side and with fingertips add black glitter to this area. Let dry and remove excess. Remove stencil. Let dry.
Wait 72 hours to wash. Machine wash warm on gentle cycle. Do not use harsh detergents or bleach. Remove promptly and line dry. To iron, turn garment inside out, being careful not to touch design with iron. Do not dry-clean.