Turquoise Howlite Bangle Bracelet
- Beadalon® Wire, 24 ga. – Hematite (48")
- Beadalon® Chain Nose Pliers
- Beadalon® Wire Cutters
- Bead Gallery® Flat Stones – Dyed Turquoise Howlite
- Bead Gallery® Rondelles – Dyed Turquoise Howlite
- Bead Landing™ Bracelet
Step 1 Cut two 24" pieces of 24 ga. hematite wire.
Step 2 Just below the small flower shape on the bracelet, feed both ends of the wire from bottom through the bracelet and twist together to secure.
Step 3 Thread both wire ends through one of the flat Howlite stones.
Step 4 Hold stone tightly in place and separate wires. Feed each wire down through the bracelet.
Step 5 Pull wire ends, (together), back through bracelet and thread another flat Howlite stone.
Step 6 Repeat Steps 3-5 three additional times.
Step 7 Trim wire and tuck sharp ends so they do not touch skin or pull clothing.
Step 8 Repeat Steps 2-7 on opposite side. When you get to the top, do not twist wire.
Step 9 Slide one wire through the round bead; down through the back of the bracelet; back up to the top. Repeat with remaining wire, but thread wire through opposite hole.
Step 10 Begin to wrap the wire around and under the round bead to further secure.
Step 11 Tuck sharp ends so they do not touch skin or pull clothing.