Wedding Brooch Bouquet
- Silk Flowers
- Modern Romance Bouquet Holder
- Celebrate It® Satin Wired Ribbon, Mega Roll – White
- Bead Landing™ RSVP Collection Pendants
- Jewelry Essentials™ Wire, 20 gauge
- Low Heat Glue Gun
- Bead Gallery® Faceted Crystal Beads
- Bead Landing™ Pearls
- Heavy Duty Wire Cutters
Step 1 Cut a 20" length of ribbon and pull the wire from one side of the ribbon to gather the ribbon into a circle.
Step 2 Tie off the wire and trim with wire cutters.
Step 3 Glue the curled ribbon to the underside of the bouquet holder, covering all.
Step 4 Cut five 10" lengths of ribbon. Fold in half and glue to the underside of the bouquet holder, ensuring the cut ends of the ribbon begin just past the top of the handle.
Step 5 Attach the brooches to the center of the flowers using the pin on the brooch or a small amount of hot glue.
Step 6 Place small pearls and faceted crystals onto the 20 gauge wire. Fold into a loop and twist to secure the beads in place. Trim the length of the beaded wire to match the length of the bouquet handle.
Step 7 Arrange the flowers and bead wires into a bouquet and wrap with tape.
Step 8 Set the bouquet into the bouquet holder.
Step 9 Using the heavy duty wire cutters, trim the stems and wire to the desired length.
Step 10 Wrap the handle with ribbon, starting with a piece glued around the bottom of the stems, from side to side, then wrap the whole handle. Secure with glue.
Step 11 Tie a bow with the ribbon and glue to the handle.